High Precision Vertical Machining Center
Clean Rough-Cut & Fine Finish at Superb Efficiency
V-8i RAPID0 32
- FANUC Oi-MD digital CNC/AC servo package.
- HSK63A taper, built-in 24000rpm spindle with cooling system.
- 850 x 520 x 610mm working range.
- 3 axis rapid 32 meters/min.
- 1000 x 520mm work table.
- 700kgs. table load.
- ARM type 30 tools ATC+1.5 seconds quick tool change device.
- Auto screw drive chip conveyor.
|Inverter motor drive 20 tools armless ATC system side-opening for loading tools, auto-closed magazine cover during machining.||All 3 axis are directly coupled, this direct positive drive provides backlash-free, noise-free and vibration-free machining performance.||All jigs and dials used for calibration are inspected and approved by the industrial metal development center to ensure accuracy.|
|Optional arm type 24 or 30 tools ATC quick tool-change mechanism, tool to tool 1.5 seconds.||The X,Y,Z-axis slideways on V-11 series are mounted with 45mm linear guideways. Each linear guideway is fitted with 3 blocks, total 6 blocks on both sides. This results in increased stability for faster cutting feed rate.||ATC magazine protected by sheet metal cover, also during each atc cycle, chips on cutting tool will be automatically cleaned by brushes which installed at magazine cover opening.|
|"THK" LM guideways heavy duty type 45mm width, plus over-sized guideblocks fitted on all 3 axis. Standard rapid traverse 32Mlmin. 48Mlmin rapid traverse is optional.||No counter balance of any kind required, over-capacity Z axis brake motor enhance Z axis feeding speed & precise positioning.||Axial ballscrew holder & motor holder are precisely internal grounding which guarantee ballscrew rotating at high precision due to much less heat deformation.|